fbpixel
 

CAD $ 615.99 Neuspeed Power module 2.0 TSI Gen II

Neuspeed Power module 2.0 TSI Gen II #64.10.13

NEUSPEED Power Module is a device which easily allows most able person to upgrade the performance of their 2008.5-up Audi / VW Gen II 2.0L TSI without reducing the reliability or integrity of the engine, clutch and driveline. This is the simplest and best alternative or option to chip tuning. The NEUSPEED Power Module is an all new design, not some rebranded 3rd party product. It is a plug and play box that intercepts at the MAP and Boost sensors and can be installed or removed within minutes without any detection. There is a convenient two position switch for 91+ premium fuel and 100+ octane race fuel for maximum HP output. The electrical components are housed in a billet aluminum enclosure which is protected from the elements and is designed and manufactured to be positioned within the engine bay of your vehicle. The wire harness is manufactured using automotive quality wiring which is both oil and heat resistant, and has the same OE water proof connectors as used on your engine.

NEUSPEED Power Module's are designed, engineered and tuned for a specific engine, not a generic box.

Adjustable Settings:

  • Stock Boost
  • +5 PSI Increase
  • +8 PSI Increase

Power Gain - 91 Octane Fuel (higher gains obtainable with better octane fuel):

  • +5 PSI / 35 HP - 45 TQ
  • +8 PSI / 50 HP - 60 TQ

Increases boost by modifying the charge pressure and map sensor readings

Allows ECU to remain in control of boost

The actual boost is increased by a precise amount
Boost is increased in a gradual, progressive fashion
Uses the closed loop control of the ECU to increase boost
Readings in the vacuum region are stock

No effect on cold start
No effect on warm-up
No change to idle, cruise and moderate acceleration modes of operation
Retains stock ECU programming

No change to factory ECU programming, communication or safety protocols
No ECU TD1 code to void manufactures warranty
Not effected by ECU reprogramming by the dealer
Makes use of existing ECU programming for higher boost levels
Correct Air/Fuel mixture maintained from the wide band O2 and closed loop mode of the ECU
Ignition timing optimized by the ECU
Easy Installation

Plug-and-play intercept at Boost and MAP sensor connector locations
Installation or removal can be completed in a few minutes (depending on model)
No trace Power Module was ever there after removal
Power Module can be sold or installed on another vehicle of the same engine type.
Notes:

Fits: 2008.5-UP Audi (A3, A4, A5, A6, Q5, TT) and VW (CC, EOS, GTI, JETTA, PASSAT, TIGUAN) with Gen II 2.0L TSI Engine (Longitudinal or Transverse) with MAF (mass air flow) Sensor.

CARB Pending. Emission testing to be California compliant and any states that follow.

Designed and Engineered Camarillo, California. Made in USA

NOTE: NEUSPEED P-FLO Air Intake and Hi-FLO discharge pipe highly recommended

DO NOT USE POWER MODULE IF ECU HAS BEEN TUNED OR MODIFIED.

Brand : Neuspeed
MFG Part # : 64.10.13
Price : CAD $ 615.99

This product may not fit all the vehicles listed. Please make sure it is the right part for your application or contact us for more information.


May also fits these cars

Open an account

Creating an account will enable you to order online and to customize your web experience. Euro Part Import will never share your data.

Open an account

Forgot your password?

Already a member?